描述
Digi Zigbee XBee PRO S2C ZigBee w/63 mW Wire Antenna通訊模組
Digi Zigbee XBee PRO S2C Zigbee 模組 (802.15.4) Zigbee模組(802.15.4) XBee PRO ZB S2C TH Wire Antenna
Digi Zigbee XBee PRO S2C ZigBee w/63 mW Wire Antenna通訊模組 特色
- RF 250Kbps，串行速率高達1Mbps數據速率
- 通過UART，SPI或無線（OTA）進行固件升級
- 室內/城市範圍高達300英尺（90米），室外/射頻視距範圍可達2英里（3200米）
- 發射功率為63mW（+ 18dBm）
- 接收器靈敏度為-101dBm
- ISM 2.4GHz頻段，DSSS（直接序列擴頻）抗干擾性
- （4）10位ADC輸入，15位數字I / O，128位AES加密
- 工作溫度範圍為-40°C至+ 85°C，電源電壓範圍為2.7V至3.6V
- 尺寸為0.960英寸x 1.297英寸（2.438厘米x3.294厘米）
- 3.3VDC時的發送電流為120mA，3.3VDC時的接收電流為31mA
應用
射頻通信，無線，通信和網絡
原廠 Digi XBee And Digi XBee-Pro Zigbee Datasheet PDF
Digi Zigbee XBee PRO S2C 規格
- 頻率: 2.4 GHz
- 範圍: 2 mile
- 數據率: 250 kb/s
- 靈敏度: – 101 dBm
- 工作電源電壓: 2.7 V to 3.6 V
- 電源電流傳輸: 120 mA
- 電源電流接收: 31 mA
- 輸出功率: 63 mW
- 最高工作溫度: + 85 C
- 尺寸: 3.294 cm x 2.438 cm
- 封裝: Tray
- 品牌: Digi International
- 接口類型: SPI, UART
- 天線連接器類型: Wire
XBee PRO S2C ZigBee w/63 mW Wire Antenna
This is the XBee XBP24CZ7WIT-004 module from Digi. The new Series 2C improves upon the power output and data protocol of the Pro Series2. Series 2C modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.
The XBee/XBee-PRO ZB (S2C) introduces the SPI serial interface to Digi’s through-hole ZigBee radio. Please refer to the XBee/XBee-PRO ZB (S2C) product manual for more information.
Note1: If you are looking for a simple point-to-point configuration, you might want to try the Series 1 instead. The Series 2 requires considerable setup and configuration.
Note2: Series 1 and Series 2B XBee modules have the same pin-out. However, Series 1 modules cannot communicate with Series 2B modules.
Note3: If you are using these outside of the United States, please check with your local laws regarding radio communication.
商品評價
目前沒有評價。