- 描述
- Size Guide
- 評價 (0)
描述
描述
DC 電源降壓模組 8-35V 降壓 5V 8A 4路USB 輸出
DC 電源降壓模組 有 4路獨立專用充電管理IC、可有效支持各種手機進行最大電流充電、充電速度快、安全可靠。
- 充電識別IC兼容蘋果安卓全系列產品,絕大部分手機都可以達到最快充電速度。
- 支持4路USB同時進行2A電流充電,電流大充電快,總輸出電流可達到8A。
- 輸入採用MOS管反接保護,最大限度的提高了轉換效率,降低損耗。
- 輸出帶過壓保護,看有效保護手機。
- 8-35V超寬輸入電壓,12V 24V 汽車均能完美支持。
- 同步整流方案,可有效降低發熱量、提高效率,效率最高可達到96%。
- 行業先進的扁平線大電流電感,電流大發熱小,轉換效率高。
- 4個高品質貼片電容,再加大容量MLCC電容,輸出紋波更低、干擾更小。
- 高品質雙層鍍金USB口,壽命是普通USB 的2倍。
- 默認發貨為輸出電壓為5.2V左右。
模組規格參數:
- 輸入電壓:DC 8-35V
- 輸入電流:5.5A
- 輸出電壓:5.2V
- 輸出電流:總最大8A,電流自適應,手機單口充電最大2A。
- 動態響應速度:300us (負載流流變化5%)
- 轉換效率:95%(12V轉5.2V3.5A測得,效率跟壓差和負載大小有關。)
- 負載調整率:0.2-0.3%(10%-50%負載12V輸入測得)
- 紋波&噪聲:120mVP-P(20MHz帶寬12V轉5.2V3A測得)
- 開關頻率:100KHz
- 空載電流:18mA (12V車5V測得)
- 接線方式:IN輸入 OUT輸入 接線端子DC座
- 固定方式:M3*1 M2*2
- 淨重:約36克
支持設備 :
- 手機,數碼相機,平板電腦,導航儀,行車記錄儀等需USB 供電的設備。可以同時為4部手機充電,4路總電流8A。
- 多種輸入輸出方式,支持接線端子輸入、DC座輸入,輸出支持4*USB 輸出、接線端子輸出5V 。
- 外觀尺寸:54(長)*39(寬)*21(高) mm (含USB口)
- 引腳方式:VIN+輸入正極、GND公共地、OUT+輸出正極
注意事項:
- (1)不要過壓和超負荷使用,否則會損壞電池和電源。
- (2)模塊只能降壓不能升壓,不能給高於輸入電壓的電氣設備供電。
- (3)長時間大電流大功率滿載工作時要注意通風散熱,以延長本電源的使用壽命。
- (4)請勿長時間滿負荷工作,持續工作時請留20%的餘量,注意通風散熱
8A DC-DC Buck Power Module 9V 12V 24V (8-35V) to 5V 4-Port USB Interface USB Car Charger Module for USB Port Power Devices
- Non-isolated synchronous rectification step-down power supply module, 4-Channel independent dedicated charge management IC, can effectively support a variety of mobile phones for maximum charge compatible with Apple / Andrews products
- Support 4-Channel USB at the same time 2A current charging, fast charging current, the total output current up to 8A.
- DC8-35V wide input voltage, the input with reverse polarity protection to maximize the conversion efficiency and reduce losses. Output with overvoltage protection.
- With 4 high-quality chip capacitors, a large capacity MLCC capacitor, the output ripple is lower.
- High-quality double-plated gold USB port, life is 2 times the normal USB
Input voltage: DC 8-35V;
Input current: 5.5A;
Output voltage: 5.2V;
Output current: 8A (4xUSB output, maximum 8A, a single USB output maximum 2A);
Dynamic response speed: 300us (load flow changes 5%);
Conversion efficiency: 95% (12V to 5.2V3.5A measured efficiency with the pressure and load size.);
Load regulation: 0.2-0.3% (10% -50% load 12V input measured);
Ripple & Noise: 120mVP-P (20MHz bandwidth of 12V to 5.2V3A measured);
Switching frequency: 100KHz;
No-load current: 18mA (12V car 5V measured);
Wiring: IN input, OUT input, terminals, DC outlet;
Fixing method: M3 * 1 M2 * 2;
Net weight: 36 g;
Support Device :
A variety of input and output, support for terminal input, DC input, output support 4 * USB output, the output terminal 5V.
Package Included:
1x8A DC-DC Buck Power Module
商品評價
目前沒有評價。